Annual Service Plans
Most standby units need a full service once a year. Our annual plan covers the oil, filters, battery test, and load test on a set schedule. It is the schedule most manufacturers require to keep the warranty intact.
A standby generator only helps if it starts on the worst night of the year. The way to trust it is regular service, not hope. Middle Tennessee Generator keeps your unit tuned, tested, and ready through every storm and cold snap. We handle the oil, filters, battery, and load test so you never find out the hard way.
Different homes and units need different care schedules. These are the maintenance options we offer across Middle Tennessee.
Most standby units need a full service once a year. Our annual plan covers the oil, filters, battery test, and load test on a set schedule. It is the schedule most manufacturers require to keep the warranty intact.
Hard-working units and commercial systems often need service twice a year. We split the work into spring and fall visits to stay ahead of storm season. It is the schedule most manufacturers require to keep the warranty intact.
When a major storm is forecast, a quick check buys peace of fast confidence. We verify fuel, battery, and start-up so the unit is ready when it counts. It is a fast, low-cost way to trust the unit before severe weather.
Batteries, plugs, and filters wear on a schedule you can plan for. We replace them before they fail, not after they leave you in the dark. Planned replacement is always cheaper than an emergency call in the dark.
A neglected generator looks fine right up until it fails. These are the problems that build quietly between the storms.
Oil breaks down with heat and time, even when the unit barely runs. Dirty oil and clogged filters wear the engine and shorten its life.
A battery left untested slowly loses its charge over months. When the outage hits, it cannot turn the engine over to start.
Fuel systems gum up when a unit sits unused for long stretches. That buildup starves the engine right when the household load comes on.
Generator maintenance is more than an oil change. Here is the full sequence we run on every service visit.
We start by reading the controller history for any logged faults. That tells us what the unit has struggled with since the last visit. Catching a logged fault early is far cheaper than a failure during a storm.
We change the oil and filter on the schedule your unit and run hours call for. Clean oil is the single biggest factor in engine life. We use the oil weight your unit calls for, not a one-size substitute.
We check and replace the air filter and spark plugs as needed. Clean intake and strong spark keep the engine starting fast and running clean. Worn plugs are a quiet cause of hard starts that this step prevents.
We load-test the battery and confirm the charger holds it ready. A weak battery is the top cause of a no-start, so this step matters most. We document the battery age, so you know when a replacement is coming.
We inspect the gas or propane supply and tighten electrical connections. Loose lugs and low fuel pressure both cause failures under load. Loose lugs heat up under load, so this quick check prevents real damage.
Finally we simulate an outage and run the unit under household load. You get proof it works, not just a checklist with boxes ticked. A passing checklist means nothing if the unit cannot carry your home.
A standby unit gives you hints when it needs attention. If any of these apply, it is time to schedule service.
Manufacturers set annual service for a reason. A unit past that mark is running on old oil and an aging battery. Every month past that mark raises the odds of a no-start.
A weekly self-test that cranks slow or runs uneven is a warning. The unit is telling you something before it leaves you in the dark. A rough weekly test is the unit asking for attention before it fails.
Any alarm on the controller means a logged fault. Those do not clear on their own and should be checked promptly. The longer a fault sits, the more it can cascade into bigger damage.
A generator that never ran all summer can have stale fuel and a flat battery. A service visit confirms it is ready before the next storm. A quick service confirms it will actually start when you finally need it.
A maintenance plan is only as good as the team behind it. A few things set ours apart.
A checklist is not proof a generator works. We run the unit under real household load, so you know it will start when it counts. You get proof of readiness, not just a stamped inspection sheet.
We maintain Generac, Kohler, Cummins, Briggs and Stratton, and Champion units. One plan covers whatever brand sits on your pad. You never have to track down the original installer for routine care.
Most no-starts come from a worn part we could have replaced. We flag battery, fuel, and filter issues before they become an outage failure. That foresight is the difference between a service call and an outage failure.
A light-use home and a commercial system need different care. We set the schedule to your unit and run hours, not a generic calendar. A schedule that fits your usage keeps you from paying for service you do not need.
We install and service generators across the entire Middle Tennessee region. Our coverage runs from the heart of Nashville to the surrounding suburbs and rural counties. Wherever you are, the same team handles the sizing, permits, and service.
If your town is not listed, reach out anyway, because our crews cover communities across Middle Tennessee every day.
These are the questions Middle Tennessee homeowners ask about keeping a generator ready. Here are straight answers.
The worst time to learn your generator failed is during an outage. Middle Tennessee Generator will service your unit, load-test it, and keep it on a schedule you never have to think about. When you want your standby system kept ready, schedule generator maintenance and we will put you on the calendar.